Latest news

Industrial roof

Simple support with tie or flange

System for the support of PV panels on industrial polyurethane roofs with a flange fitted to a trapezoidal sheet metal or support with a tie with a strip and clamping nut for plain steel metal for vertical (portrait) or horizontal (landscape) panel layouts and holding of panels with 2 rods for each row.

» Read more...

Support with raising accessory

PV panel support system allowing the raising of the panels 10 to 18cm from the roof in industrial polyurethane roofs, with a flange with an accessory that fits in the trapezoidal sheet metal for vertical (portrait) panel layouts, retained with a A1800 rod along the panels. We recommend a flange with a raising accessory for the better ventilation of panels or due to other constraints.

» Read more...

Support with angled bases

Fixed angled support bases for PV panels, if allowed by the urban planning service of the area, strictly for single panel rows and bases without raising from the level of the roof. The self-tapping screws do not suffice to fasten the flange to the roof, so it is fastened using either a larger self-tapping screw or a rod and clamping nut in the existing substructure under the sheet plate that holds the industrial roof. We propose the angled bases for industrial roofs when the tilt is inverted to the south.

» Read more...



Contact

Sales Department
Tel: +30.22950.98840-2
Fax: +30.22950.98839
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Factory & Exhibition
42nd km Nat.Road Athinon-Lamias, GR-19011 Avlonas Attica, Greece (map)
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Newsletter

Subscribe to our newsletter